2004-2007 Kawasaki Ninja ZX10 HID Installation Manual

download
The hole made with a dremil, must be large enough for the main power wire to fit. The hole must be no more than an inch in diameter. The trick is to make the hole about ¾ of an inch to an inch and insert the wire diagonally to avoid creating a larger hole. If needed, make the hole larger on opposite sides only to create extra space for the power connectors. Push the rest of the wires through the hole, along with the rubber grommet. Then from the opposite side push the grommet into the dust cover, splitting sides to fit it over the hole. If installed properly, this is how the grommet should cover the hole that you made in the dust cover. One bulb prepped for installation. Both bulbs ready for installation. Take off the power plug from the original bulb Take out the original bulb and install the HID bulb. Be careful, not to touch the HID bulb at any time. Plug in the power wires into the original power plug. They go in easy and slide right in. Black wire connects into the black wire on the plug. On the right side, pink goes to red. On the left side, blue goes to red as these are positive wires. Pull the wires toward you slowly and carefully as you near the cover toward the headlight. Spin the rubber grommet if you need to line up the dust cover to the head light. Now lock it in. The arrow should point up if it is locked in properly

Incoming search terms:

• power commander for zx10 04-05
• where do inner side panels go on a 2007 kawasaki zx10
• zx10 05